Configuring RAMN’s scripts

Follow the steps in Flashing Scripts to install RAMN’s scripts.

You can modify the following settings in scripts/settings/windows.ini (when using Windows) and scripts/settings/linux.ini (when using Linux):

• PORT specifies the serial port name used by scripts (e.g., COM1 or /dev/ttyACM0). You can use “AUTODETECT” to let the scripts automatically find a RAMN port.

• ECUx_FIRMWARE_PATH specifies the firmware files used to reprogram/verify the firmware of ECUs.

• VERBOSE specifies the verbose level of scripts (0 to only output errors, 4 to output everything including debug messages).

• TIMEOUT specifies the timeout value for reading from the serial port.

• CAN_NAME specifies the name of the channel for scripts that rely on CAN rather than serial.

• CAN_TYPE specifies the name of the interface type for the CAN connection above.

• CAN_REFRESH_RATE specifies how often scripts should update the CAN bus (for scripts that use CAN).

• VCAND_HARDWARE_PORT is the default hardware port used by the vcand scripts.